US probes why a router installation sparked mass flight grounding
Summary
A router installation by L3Harris Technologies at an FAA communications site in El Dorado, Arkansas, triggered a nearly five-hour nationwide aviation ground stop on Friday, Sean Duffy said on Monday. The disruption resulted in more than 18,000 canceled flights and affected communications and radar feeds at 17 of the FAA’s 22 en route centers. Officials have not determined why the installation overloaded the network. Duffy urged Congress to fund a replacement telecom network operated by AT&T, Verizon and Lumen.
Key Facts
- The overload involved 1,000 connection attempts every four to five seconds, Duffy said.
- The FAA said its initial investigation pointed to possible data overload at sites in El Dorado and Amarillo, Texas; Duffy said L3Harris had replaced the Amarillo router three weeks earlier.
- The FAA said L3Harris blocked the two locations when data inconsistencies occurred and disabled broadcasting on all the new routers as a precaution.
- The Juniper Networks routers installed by L3Harris were replacing Cisco routers produced in 2001 that the FAA said were supposed to have been replaced in 2006.
- Shares of L3Harris fell 3.3 percent and Hewlett Packard Enterprise shares fell 4.5 percent on Monday. HPE said the Juniper device was functioning as intended based on information available Sunday.

U.S. Secretary of Transportation Sean Duffy holds a press conference after the FAA issued a national ground stop yesterday, at the Department of Transportation in Washington, DC, Saturday. Reuters-Yonhap
WASHINGTON — U.S. Transportation Secretary Sean Duffy said on Monday it remains unclear why a router installed by L3Harris Technologies in a remote Arkansas facility triggered a nearly five-hour nationwide aviation ground stop on Friday,resulting in more than 18,000 canceled flights.
Shares of L3Harris, the contractor for the Federal Aviation Administration (FAA), fell 3.3 percent after the government blamed the mass flight shutdown on its router installation.
Shares of Hewlett Packard Enterprise, which owns Juniper Networks, the maker of the routers that L3Harris installed, dropped 4.5 percent on Monday.
L3Harris has said it is cooperating with the official investigation into what went wrong.
Duffy, speaking on CNBC, said the installation at an FAA radio communications site in El Dorado led to an overload of a key government communications system at a rate of 1,000 connection attempts every four to five seconds.
That destabilized aircraft communications and radar feeds, affecting 17 of 22 FAA en route centers and prompting the ground stop, Duffy said, adding that he has urged Congress to fund the construction of a new telecom network that is not owned by L3Harris.
The FAA had said on Sunday that the initial investigation suggested the data overload could have happened in two locations: the El Dorado site and a radar site in Amarillo, Texas. Duffy said L3Harris had replaced the router in Amarillo three weeks earlier.
The FAA said that when the data "inconsistencies" occurred, L3Harris blocked those two locations, stabilizing the network. The broadcasting function was also disabled on all the new routers as a precaution, it added.
L3Harris had been installing Juniper Networks routers to replace Cisco routers, produced in 2001, which were supposed to have been replaced in 2006, the FAA said.
Hewlett Packard Enterprise said that the Juniper device was "functioning exactly as intended" based on what it knew on Sunday.
Duffy has asked for billions of dollars from Congress to build a new network operated by AT&T, Verizon, and Lumen.
"I have the architecture ready. These companies are ready to deploy tomorrow. All I need is the money to tell them to start," he said on NBC on Sunday. "I want to get away from L3Harris and get to a new one. But they own the network. So I can’t cancel the network that they own and I operate on."
Explore More
- Q.
- Q.
- Q.